Trapezoid Batting Cage Frame Kit 12ft x 12ft x 70ft

Note: The Legs should be staked or anchored down in areas where there is a possibility of moderate to high wind. Anchors are not included.

Kit Includes the Following Parts:
(A) 3-Way Corners 4 pcs.
(B) 4-Way Corners 12 pcs
(C) Pipe Extensions 24 pcs.
(E) Pipe End Caps 16 pcs
(F) Self Drilling Screws 26 pcs
(G) Net Hangers 50 pcs

Kit Does NOT Include the Following Parts:
(CL) 10' Length of EMT 38 pcs NOT INCLUDED

Note: The Legs should be staked or anchored down in areas where there is a possibility of moderate to high wind. Anchors are not included.

You will need an area about 73' Long & 16' Wide. It is recommended that you mark off this area before starting.
1. Lay out two of the 3-way end corners (A) 12' apart at one end where your frame will be, with 4" pipe pieces facing inward.  
2. Measure 70' and lay out the other two 3-way end corners (A) the same way.  
3. Lay out the 4-way arch corners (B), between the end arches so that they are a little more than 10' apart.  
4. Assemble the eight 28" pipes (C) to seven 10' lengths for the top cross members (CL) of the arches by inserting a self-drilling screw (F) into where the two pipes attach, to attach them together.  
5. Assemble 28" pipes (C) to 16 of the 10' length vertical poles by inserting self-drilling screws (F).
6. Assemble the arches by adding 14 of the 12' lengths (CL+C) to all of the corners (A) and (B) for the vertical legs, and the seven extended top cross members (CL) to the top of the arches.
7. Stand up one end arch and attach a 10' runner to each of the end corners. Connect the runners to the second arch. Add the rest of the runners.  

HANGING YOUR BATTING CAGE NET 
1. Lay out your batting cage inside the frame and find the top three ropes and tie them to the end arch and then do the same to the other end.
2. Attach the hanger clips to the rope and the net together along one side of the net, then the middle, and then the other side. If you do not get the rope and the net together, it will not hold up your net. Then take the lanyard part of the hanger and tie it around the pole. At this point, you can adjust how tight you want the net to hang.
3. Tie the bottom rope tails to the bottom part of the end arch legs to prevent the wind from blowing the net inward.